Client -> Fallback status point DescriptionĬlient -> Global catalog domain controllerĪ Configuration Manager client doesn't contact a global catalog server when it's a workgroup computer or when it's configured for internet-only communication.
It doesn't configure the outbound (send) rules.
TINYTERM PORTS WINDOWS
When you enable a distribution point for PXE, Configuration Manager can enable the inbound (receive) rules on the Windows Firewall. If you enable a host-based firewall, make sure that the rules allow the server to send and receive on these ports. Client -> Distribution point, both standard and pull Description Client -> Cloud management gateway (CMG) Descriptionįor more information, see CMG data flow. Client -> Configuration Manager Network Device Enrollment Service (NDES) policy module DescriptionĬlient -> Cloud distribution point Descriptionįor more information, see Ports and data flow. Descriptionįor more information, see Windows PE Peer Cache. However, any host-based firewalls on these client computers or intervening network devices within the subnet must permit ICMP traffic for wake-up proxy communication to succeed. ICMP doesn't have a UDP or TCP protocol number, and so it isn't listed in the below table. ICMP is sometimes referred to as ping commands. Clients use this communication to confirm whether the other client is awake on the network. Wake-up proxy also uses ICMP echo request messages from one client to another client. Indicates that either computer can start communicationĪsset Intelligence synchronization point -> Microsoft DescriptionĪsset Intelligence synchronization point -> SQL Server Description > Indicates that one computer starts communication and the other computer always responds The arrows in the section title show the direction of the communication:
The following sections detail the ports that are used for communication in Configuration Manager. Non-configurable portsĬonfiguration Manager doesn't allow you to configure ports for the following types of communication:Ĭonfiguration Manager console to SMS ProviderĬonfiguration Manager console to the internetĬonnections to cloud services, such as Microsoft Azure You can change these ports during setup or in the site properties. Be sure to review these ports that define the IP filter information for IPsec policies or for configuring firewalls.īy default, the HTTP port that's used for client-to-site system communication is port 80, and 443 for HTTPS. Configuration Manager then uses these ports during communications to the reporting services point. You configure the ports for the reporting services point in SQL Server Reporting Services.
0 kommentar(er)
